The LT 150A 6S Brushless ESC is a customized full featured 1/8th scale car/truck brushless speed controller.

This brushless ESC is intended for use with 4-6S Lipo.  It is suitable for most 1/8th and 1/10th brushless vehicles and conversions.  A perfect candidate for E-Revo / E-Maxx / Summit.

Setup tip: use the speed calculator by Brian Gosselin to figure out what pinion/spur you need.  An average speed of 35-40mph is recommended.

The LT-6S-150A ESC may look similar to your typical aircraft ESCs but it is a completely different beast specially designed for RC car.  The LT-6S-150A ESC features full forward/brake/reverse operation at 150A continuous with flexible programmable features.  The best part is the included compact portable programming card which allow you to easily change any ESC functions with a few clicks of buttons.  This ESC has been through extended testing and proven to handle most 1/8th and 1/10th brushless vehicles and brushless conversions.

ESC Programming Card:

Here are some test data showing average and peak current from different setup (credit to Luciano)

Click to enlarge.

Features:

• Full protection feature including low voltage, over-heat, signal loss, startup protection and self-check.
• Compatible with sensorless brushless motor.
• Excellent startup performance, great throttle linearity and quick throttle response.
• Support highest motor speed 240,000RPM (2 poles), 80,000RPM (6 poles) and 40,000RPM (12 poles).
• Easy configure with LCD program card (included, $20 value).
• System can automatically detect throttle neutral point and neutral range is adjustable.
• Four running modes can match different requirement.
• 4 steps of maximum reverse force adjustment, 7 steps of maximum start force adjustment, 5 steps of maximum brake force adjustment, 6 steps of drag brake force adjustment and 6 steps of initial brake force adjustment.
• Full English instruction is included.

Note: For LT-6S-150A, an UBEC or individual battery pack should be required to power the receiver and servos, and the red line (+5V) in 3 pin must be pulled out!

WARNING: The internal BEC of the ESC is may be used to power programming card only.  DO NOT use to power your servos.

ESC Specs:

P/N	Continuous current	Battery Cell		Dimension (mm) L×W×H	Weight（g）	BEC （Linear For Program Card）	Program By card
		Li-XX	Ni-XX
LT-6S-150A	150A	2-6	5-18	96x55x21	180	0.2A/5V	Yes
LT-10S-120A	120A	2-10	5-30	96x55x21	180	0.2A/5V	Yes

Note: For LT-6S-150A and LT-10S-120A, an UBEC or individual battery pack should be required to power the receiver and servos, and the red line (+5V) in 3 pin must be pulled out!

WARNING: The internal BEC of the ESC is may be used to power programming card only.  DO NOT use to power your servos.